200kg Vacuum Panel Lifter for Wall Cladding Installation

The QR200T specifications list two configurations, WRYV and WRYH, with the same numerical parameters: an 850 mm lifter length, a 12,000 mm panel length and no extension beams. Each uses two suction pads measuring 150 × 490 mm, with a listed load of 100 kg per pad. Maximum traverse load is listed at 800 kg, while the complete lifter maximum load remains 200 kg. The traverse rating does not increase the panel lifting capacity.

• Industrial wall cladding. Handling sandwich wall panels for warehouses, factories and steel buildings.
• Prefabricated building assembly. Transferring and positioning compatible wall panels during modular building production and assembly.
• Panel storage and dispatch. Moving panels between staging areas and loading positions using a suitable lifter configuration and lifting system.
• Wall refurbishment. Positioning replacement panels during facade and enclosure renovation. Operating orientation and panel compatibility must match the approved equipment setup.

• Labor savings. Calculate worker-hours saved per panel multiplied by the loaded hourly labor cost and annual panel volume.
• Shorter handling cycles. Faster transfer and positioning may increase installation output and reduce lifting-equipment time per panel. Compare actual cycle times before and after adoption.
• Reduced damage and rework. Controlled panel handling may lower scratches, deformation and replacement costs. Use recorded damage rates and repair costs to measure the benefit.
• Investment payback. Annual net savings equal labor, equipment-time and damage savings minus additional operating and maintenance costs. Payback in months equals total investment divided by annual net savings, multiplied by 12. Numeric ROI requires purchase cost, operating costs and measured productivity data.